ASTM-A835 › Historical Revision Information
Standard Specification for Sizes of Ferroalloys and Alloy Additives
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers standards for sizes of screened ferroalloys and alloy additives. Products shall conform to specified nominal size, standard ordered size, maximum allowable oversize, maximum allowable undersize, and friability rating. Description of the friability ratings of the ferroalloys is also provided.
Scope
1.1 This specification covers standard nominal sizes and size tolerances of screened ferroalloy and alloy additive products. This specification provides a range of sizes as referenced in all ASTM specifications for ferroalloys and alloy additives.
1.2 The sizes and tolerances allow for varying degrees of friability upon receipt of material since some attrition may be expected in transit, storage, and handling.
1.3 Specifications of sieve sizes used to define tolerances are listed in Specification E 11. Representative procedures for evaluation of each lot are described in Methods A 610. Refer to for applicable sieve designations (see ).
Keywords
ICS Number Code 77.100 (Ferroalloys)
To find similar documents by ASTM Volume:
01.02 (Ferrous Castings; Ferroalloys)
To find similar documents by classification:
77.100 (Ferroalloys Including classification, designation, sampling, chemical analysis, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-A835/A835M-84(2005)
Revision Level
1984 R05 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Dec. 1, 2005
Document Type
Specification
Page Count
2 pages
Committee Number
A01.18