ASTM-B1 › Historical Revision Information
Standard Specification for Hard-Drawn Copper Wire
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers hard-drawn round copper wire for electrical purposes.
1.2 The values stated in inch-pound or SI units are to be regarded separately as standard. Each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. For conductor sizes designated by AWG or kcmil sizes, the requirements in SI units are numerically converted from the corresponding requirements in inch-pound units. For conductor sizes designation by AWG or kcmil, the requirements in SI units have been numerically converted from corresponding values stated or derived in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units.
1.2.1 For density, resistivity and temperature, the values stated in SI units are to be regarded as standard.
Keywords
copper electrical conductor; copper wire; electrical conductor; electrical conductor-copper; hard-drawn copper wire
To find similar documents by ASTM Volume:
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B1-90
Revision Level
1990 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
July 27, 1990
Document Type
Specification
Page Count
5 pages
Committee Number
B01.04