ASTM-B116 › Historical Revision Information
Standard Specification for Figure-9 Deep-Grooved and Figure-8 Copper Trolly Wire for Industrial Haulage
The following bibliographic material is provided to assist you with your purchasing decision:
This specification deals with figure-9 deep-section grooved and figure-8 copper trolley wire for use in industrial haulage. The material shall conform to the required tensile properties: tensile strength and elongation. Tension tests shall be made. However, elongation tests shall not be made on specimens containing joints. The electrical resistivity shall be determined by resistance measurements. The standard sizes of figure-9 deep-section grooved and figure-8 copper trolley wire are specified.
Scope
1.1 This specification covers figure-9 deep-section grooved and figure-8 copper trolley wire for use in industrial haulage (Explanatory Note 1).
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
Keywords
ICS Number Code 29.060.10 (Wires); 29.280 (Electric traction equipment)
To find similar documents by ASTM Volume:
To find similar documents by classification:
29.060.10 (Wires Including electric rods, busbars, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B116-95(2012)
Revision Level
1995 R12 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Nov. 15, 2012
Document Type
Specification
Page Count
5 pages
Committee Number
B01.04