ASTM-B131 › Historical Revision Information
Standard Specification for Copper Alloy Bullet Jacket Cups
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers bullet jacket preform cups made from UNS C22000 wrought copper alloy used for processing Types I-IV and Classes I-II bullet jackets. This standard contains information on chemical composition, grain size and testing requirements for the preform cups.
Scope
1.1 This specification establishes the requirements for bullet jacket preform cups produced of Copper Alloy UNS No. C22000 for processing into bullet jackets of the following types and classes:
1.1.1 Type I—Caliber 0.30.
1.1.2 Type II—Caliber 0.45.
1.1.3 Type III—Caliber 0.50.
1.1.4 Type IV—As specified in the contract or order.
1.1.5 Class I—Not annealed.
1.1.6 Class II—Annealed.
1.2 The values stated in inch-pound units are the standard, except for grain size, which is given in SI units. Values in parentheses are for information only.
Keywords
bullet jackets; commercial bronze cups; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B131-07
Revision Level
2007 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 1, 2007
Document Type
Specification
Page Count
4 pages
Committee Number
B05.01