Document Center is acquired by Nimonik

Scope

1.1 This specification establishes the requirements for bullet jacket preform cups produced of Copper Alloy UNS No. C22000 for processing into bullet jackets of the following types and classes:

1.1.1 Type I—Caliber 0.30.

1.1.2 Type II—Caliber 0.45.

1.1.3 Type III—Caliber 0.50.

1.1.4 Type IV—As specified in the contract or order.

1.1.5 Class I—Not annealed.

1.1.6 Class II—Annealed.

1.2 Units—Values stated in inch-pound units are to be regarded as standard, except for grain size, which is given in SI units. The values in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.

Significance and Use

For the purposes of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value, or a calculated value, shall be rounded as indicated in accordance with the rounding method of Practice E29.

Keywords

bullet jackets; commercial bronze cups ; UNS No. C22000; Ammunition; Brass; Bronze; Bullet jackets; Copper alloy--specifications; UNS C22000 (commercial bronze, 80%); ICS Number Code 77.150.30 (Copper products)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.