ASTM-B131 › Historical Revision Information
Standard Specification for Copper Alloy Bullet Jacket Cups
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers bullet jacket preform cups made from UNS C22000 wrought copper alloy used for processing Types I-IV and Classes I-II bullet jackets. This standard contains information on chemical composition, grain size and testing requirements for the preform cups.
Scope
1.1 This specification establishes the requirements for bullet jacket preform cups produced of Copper Alloy UNS No. C22000 for processing into bullet jackets of the following types and classes:
1.1.1 Type I—Caliber 0.30.
1.1.2 Type II—Caliber 0.45.
1.1.3 Type III—Caliber 0.50.
1.1.4 Type IV—As specified in the contract or order.
1.1.5 Class I—Not annealed.
1.1.6 Class II—Annealed.
1.2 Units—The values stated in inch-pound units are to be regarded as standard, except for grain size, which is given in SI units. The values in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
15.1 For the purpose of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value, or a calculated value, shall be rounded as indicated in accordance with the rounding method of Practice E29.
Property | Rounded Unit for Observed or Calculated Value |
|
|
Chemical Composition | Nearest unit in the last right-hand significant digit used in expressing the limiting value |
|
|
Grain size | Nearest multiple of 0.005 mm |
Keywords
bullet jackets; commercial bronze cups; UNS No. C22000;
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B131-17
Revision Level
2017 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
April 15, 2017
Document Type
Specification
Page Count
5 pages
Committee Number
B05.01