ASTM-B161 › Historical Revision Information
Standard Specification for Nickel Seamless Pipe and Tube
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the standard requirements for nickel (UNS N02200) and low-carbon nickel (UNS N02201) in the form of cold-worked seamless pipe and tube. The material shall conform to the specified chemical composition limits for nickel, copper, iron, manganese, carbon, silicon, and sulfur which shall be determined by chemical analysis. Tension test shall be performed; wherein, the tensile properties for the material specified as small-diameter and light-wall tube shall be in conformity with the tensile strength, yield strength, and elongation requirements. Each pipe or tube shall also be subjected to nondestructive electric test or hydrostatic test in accordance with a referenced ASTM document to determine the allowable fiber stress for the annealed and stress-relieved materials.
Scope
1.1 This specification2 covers nickel (UNS N02200)3 and low-carbon nickel (UNS N02201)3 in the form of cold-worked seamless pipe and tube in the conditions shown in Table 1 and Table X1.1.
1.1.1 Hot-worked material is available. Properties are to be agreed upon between the manufacturer and purchaser.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
seamless pipe; seamless tube; N02200; N02201;; ICS Number Code 77.150.40 (Nickel and chromium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.40 (Nickel and chromium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B161-05(2019)
Revision Level
2005 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
May 1, 2019
Document Type
Specification
Page Count
4 pages
Committee Number
B02.07