ASTM-B19 › Historical Revision Information
Standard Specification for Cartridge Brass Sheet, Strip, Plate, Bar, and Disks
Show Complete Document History
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification establishes the requirements for sheet, strip, plate, bar, and disks for the manufacture of ammunition of component parts thereof from alloy UNS C26000.
1.2 Values given in inch-pound units are the standard except for grain size which is stated in metric units. SI values given in parenthesis are for information only.
1.3 The following safety caveat pertains only to the test method described in Section 10 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
bar; brass bar; brass disks (blanks); brass plate; brass sheet; brass strip; cartridge brass bar; cartridge brass disks (blanks); cartridge brass plate; cartridge brass sheet; cartridge brass strip; disks (blanks); plate; strip; ICS Number Code 23.140 (Compressors and pneumatic machines)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B19
Revision Level
DOD VALIDATION 2
Status
Superseded
Modification Type
Revision
Publication Date
May 23, 1991
Document Type
Specification
Page Count
1 page
Committee Number
B05.01