Document Center is acquired by Nimonik

Scope

1.1 This specification covers aluminum 1350 drawing stock 0.375 in. (9.52 mm) to 1.000 in. (25.40 mm) in diameter, in the tempers shown in Table 1, for drawing into wire for electrical conductors (Explanatory Notes 1 and 2).

1.2 The SI values of density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.

Note 1-Prior to 1975, aluminum 1350 was designated as EC aluminum.

Note 2-The aluminum and temperature designations conform to ANSI H35.1. Aluminum 1350 corresponds to unified numbering system A91350 in accordance with Practice E 527.

Keywords

aluminum; aluminum drawing stock; aluminum wire; drawing stock; wire

To find similar documents by ASTM Volume:

02.03 (Electrical Conductors)

To find similar documents by classification:

77.150.10 (Aluminium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.