ASTM-B233 › Historical Revision Information
Standard Specification for Aluminum 1350 Drawing Stock for Electrical Purposes
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers aluminium 1350 drawing stock for electrical purposes. The stock shall conform to the chemical composition requirements. The stock shall be uniform in quality and temper and shall be suitable for drawing into wire. The tensile strength tests and requirements for the respective tempers of stock are presented in details. The stock shall be furnished in continuous-length coils without joints, unless otherwise agreed upon between the manufacturer and purchaser. The electrical resistivity tests shall be made on full-section samples of the stock.
Scope
1.1 This specification covers aluminum 1350 drawing stock 0.375 in. (9.52 mm) to 1.000 in. (25.40 mm) in diameter, in the tempers shown in , for drawing into wire for electrical conductors (Explanatory Note 1 and Note 2).
1.2 The SI values of density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as standard and the SI units may be approximate.
Note 1Prior to 1975, aluminum 1350 was designated as EC aluminum.
Note 2The aluminum and temper designations conform to ANSI H35.1. Aluminum 1350 corresponds to unified numbering system A91350 in accordance with Practice E 527.
Keywords
aluminum; aluminum drawing stock; aluminum wire; drawing stock; wire; ICS Number Code 77.150.10 (Aluminium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.10 (Aluminium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B233-97(2007)
Revision Level
1997 R07 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 1, 2007
Document Type
Specification
Page Count
4 pages
Committee Number
B01.07