ASTM-B249M Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings [Metric] (Withdrawn 2000)

ASTM-B249M - 1994A EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings [Metric] (Withdrawn 2000)
ORDER

Scope

1.1 This specification establishes a group of general requirements common to wrought copper and copper alloy rod, bar, shapes and forgings which shall apply to Specifications B16M, B21M, B98M, B124M, B133M, B138M, B139M, B140M, B150M, B151M, B196M, B283, B301M, and B455M to the extent referenced therein.

1.2 The chemical composition, physical and mechanical properties, and all other requirements not included in this specification shall be prescribed in the product specification.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This specification is the SI companion of Specification B249.

1.5 SI units are the measurement standard.

Note 1-Requirements for flat wire (defined as flat products up to and including 4.8 mm in thickness and up to 80 mm in width with all surfaces rolled or drawn without having been slit, sheared, or sawed) including square, furnished in coils or straight lengths, or on spools, reels, or bucks are described by wire Specifications B206M and B272.

Keywords

Carbon content; Combustion; Infrared (IR) analysis; Sulfur content; carbon/sulfur in wrought Cu/Cu-alloy rod/bar/shapes, by; combustion/infrared analysis, test,; Copper-rod/bar/shapes; Copper alloy rod/bar/shapes; General delivery requirements-Cu/Cu-alloy; rod/bar/shapes (wrought Cu/Cu alloy), general requirements, spec., (for; metric see B 249M),; Terminology-Cu/Cu alloy; Wrought Cu/Cu-alloy materials/applications; wrought Cu/Cu-alloy rod/bar/shapes, terminology, spec; ICS Number Code 77.150.30 (Copper products)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in Paper format.

Document Number

ASTM-B249M-94a

Revision Level

1994A EDITION

Status

Superseded

Modification Type

Replaced

Publication Date

Aug. 15, 1994

Document Type

Specification

Page Count

12 pages

Committee Number

B05.02