ASTM-B272 › Historical Revision Information
Standard Specification for Copper Flat Products with Finished (Rolled or Drawn) Edges (Flat Wire and Strip)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification establishes the requirements for copper products, flat wire and strip, with rolled or drawn finished edges produced for general application.
1.1.1 The product is produced in UNS Copper Nos. C10100, C10200, C10300, C10500, C10700, C10800, C11000, C12200, and C14200 unless otherwise established by agreement between manufacturer and purchaser.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.
Note 1—When a copper other than that listed in 1.1.1 is designated by the purchaser, the resulting product shall conform to the physical, mechanical, performance, dimensional, and tolerance requirements per agreement between the manufacturer and purchaser.Keywords
copper flat products; copper flat wire; copper strip; copper wire; flat wire; general purpose strip; general purpose wire; strip; wire; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B272-96
Revision Level
1996 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1996
Document Type
Specification
Page Count
6 pages
Committee Number
B05.02