Document Center is acquired by Nimonik

Scope

1.1 This specification covers extruded 6061-T6 aluminum-alloy standard structural profiles.

1.2 The profiles are limited to I-beams, H-beams, channels, angles, tees, and zees.

Note 1—For other extruded profiles in other alloys and tempers refer to Specification B 221.

1.3 Alloy and temper designations are in accordance with ANSI H35.1 and ANSI H35.1(M). The equivalent Unified Numbering System alloy designation is that in preceded by A9, or A96061 for alloy 6061 in accordance with Practice E 527.

1.4 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see .

1.5 The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems will result in nonconformance with the specification.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

aluminum alloy; standard structural profiles; ICS Number Code 77.150.10 (Aluminium products)

To find similar documents by ASTM Volume:

02.02 (Aluminum and Magnesium Alloys)

To find similar documents by classification:

77.150.10 (Aluminium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.