ASTM-B335 › Historical Revision Information
Standard Specification for Nickel-Molybdenum Alloy Rod
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers rod of nickel-molybdenum alloys (UNS N10001, N10665, N10675, and N10629)* as shown in Table 1, for use in general corrosive service.
1.2 The following products are covered under this specification:
1.2.1 Rods 5/16 to 3/4 in. (7.94 to 19.05 mm) excl in diameter, hot or cold finished, solution annealed and pickled or mechanically descaled.
1.2.2 Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm) incl in diameter, hot or cold finished, solution annealed, ground or turned.
1.3 The values stated in inch-pound units are to be regarded as the standard.
Keywords
Hastelloy alloy; Nickel-molybdenum alloys; ICS Number Code 77.150.40 (Nickel and chromium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.40 (Nickel and chromium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B335-94a
Revision Level
1994A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 15, 1994
Document Type
Specification
Page Count
4 pages
Committee Number
B02.07