ASTM-B372 › Historical Revision Information
Standard Specification for Seamless Copper and Copper-Alloy Rectangular Waveguide Tube
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers seamless copper and copper-alloy rectangular waveguide tube intended for use as transmission lines in electronic equipment. Four types of material are specified having the following nominal compositions: C10200, C10300, C12000, and C22000. The copper and copper-alloy tubes shall be finished by such cold-working and annealing operations as are necessary to meet the required properties. The material shall conform to the chemical requirements specified. The material shall conform to the Rockwell hardness requirements prescribed. The test specimens of copper UNS nos. C10200, C10300, and C12000 shall be free of cuprous oxide. It is to be expected that samples of Copper UNS Nos. C10200, C10300, and C12000 shall be capable of passing the embrittlement test. It is to be expected that samples of copper UNS nos. C10200, C10300, and C12000 will conform to the prescribed electrical resistivity requirements. Samples for chemical analysis shall be taken accordingly.
Scope
1.1 This specification establishes the requirements for seamless copper and copper-alloy rectangular tube intended for use as transmission lines in electronic equipment. Five types of material are specified having the following nominal compositions:2
| Copper or | Previously | Nominal Composition, % | ||
| Copper | Zinc | Phosphorus | ||
|
|
|
|
|
|
| C10100 | Copper, Type OFEA | 99.99B | ... | ... |
| C10200 | Copper, Type OFA | 99.95B | ... | ... |
| C10300 | Copper, Type OFXLPA | 99.95B | ... | 0.003 |
| C12000 | Copper, Type DLPA | 99.90B | ... | 0.008 |
| C22000 | Commercial | 90 | 10 | ... |
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use
15.1 For purposes of determining compliance with the specified limits for requirements of chemical composition, hardness, and electrical resistivity, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.
Keywords
seamless copper and copper alloy rectangular tube; waveguide tube; UNS No. C10100; UNS No. C10200; UNS No. C10300; UNS No. C12000; UNS No. C22000;
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B372-17
Revision Level
2017 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 15, 2017
Document Type
Specification
Page Count
7 pages
Committee Number
B05.04