ASTM-B411 › Historical Revision Information
Standard Specification for Copper-Nickel-Silicon Alloy Rod and Bar
The following bibliographic material is provided to assist you with your purchasing decision:
This specification establishes the requirements for copper-nickel-silicon alloy rods and bars in straight lengths produced from Copper Alloy UNS No. C64700. The materials for manufacture shall be cast billets or ingots of such soundness and structure as to be suitable for processing by hot extrusion or rolling, and finished by cold working, annealing, cooling, straightening, and precipitation heat treatment to produce finished products that achieve the required properties. Products shall be tested and shall adhere to dimensional (diameter, length, straightness, and edge contour), mechanical (tensile and yield strength, and elongation), electrical resistivity, and chemical composition requirements.
Scope
1.1 This specification establishes the requirements for copper-nickel-silicon alloy rod and bar produced from Copper Alloy UNS No. C64700 in straight lengths.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
Keywords
copper-nickel-silicon alloy bar; copper-nickel-silicon alloy rod; UNS C64700 bar; UNS C64700 rod; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B411/B411M-14
Revision Level
2014 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 1, 2014
Document Type
Specification
Page Count
3 pages
Committee Number
B05.02