Document Center is acquired by Nimonik

Scope

1.1 This specification covers the requirements for rod drawing stock in diameters from 1/4 to 13/8 in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.

1.2 The values stated in inch-pound units are the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to Section 13. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

copper redraw rod; electrical conductors; oxygen-free copper; tough-pitch copper; ICS Number Code 29.050 (Superconductivity and conducting materials)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

29.050 (Superconductivity and conducting materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.