Document Center is acquired by Nimonik

Scope

1.1 This specification establishes the requirements for high conductivity tough-pitch copper wire bars, cakes, slabs, billets, ingots, and ingot bars.

1.2 Copper under this specification corresponds to the designations "ETP" (UNS C11000) and "FRHC" (UNS C11020) as shown in Classification B224. These coppers may also be used to produce coppers corresponding to the following:

Copper UNS No. Classification B 224 Designation C11300, C11400, C11500 ∧ C11600 STP C12000 DLP C12200 DHP C12300 DHPS C14500 DPTE

1.3 Although this specification includes certain UNS designations as described in Practice E527, these designations are for cross reference only and are not specification requirements. Therefore in case of conflict, this ASTM specification shall govern.

1.4 In this specification inch-pound units are the standard except for electrical resistivity which is expressed in SI units. The values given in parentheses are for information only.

Keywords

billets; cakes; electrolytic copper; electrorefined copper; electrowon copper; fire-refined copper; high-conductivity copper; ingots; ingot bars; refinery shapes; slabs; tough-pitch copper; wire bars; ICS Number Code 77.150.30 (Copper products)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.