ASTM-B581 › Historical Revision Information
Standard Specification for Nickel-Chromium-Iron-Molybdenum-Copper Alloy Rod
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers rod of Ni-Cr-Fe-Mo-Cu alloys (UNS N06007, N06975, N06985, and N06030)* as shown in Table 1, for use in general corrosive service.
1.2 The following products are covered under this specification:
1.2.1 Rods 5/16 to 3/4 in. (7.94 to 19.05 mm) excl in diameter, hot- or cold-finished, solution annealed and pickled or mechanically descaled.
1.2.2 Rods 3/4 to 3 1/2 in. (19.05 to 88.9 mm) incl in diameter, hot- or cold-finished, solution annealed, ground or turned.
1.3 The values stated in inch-pound units are to be regarded as the standard.
Keywords
Corrosive service applications-bars/rods/shapes; Nickel alloys-rod/bar/wire; Nickel-chromium-iron-molybdenum-copper alloys; ICS Number Code 77.150.40 (Nickel and chromium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.40 (Nickel and chromium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B581-93
Revision Level
1993 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 15, 1993
Document Type
Specification
Page Count
4 pages
Committee Number
B02.07