ASTM-B702 › Standard Specification for Copper-Tungsten Electrical Contact Material
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers electrical contact components made from copper tungsten by powder metallurgical procedures. The material shall conform to the chemical composition limits as agreed upon between the manufacturer and the user using the newest edition of Annual Book of ASTM standards, or any other approved method agreed upon. Qualification tests for determination of physical properties shall be performed on production parts, wherever practical or applicable. The tests shall be determined after consideration of the function of the part.
Scope
1.1 This specification covers electrical contact components made from copper tungsten by powder metallurgical procedures.
1.2 This specification covers compositions within the copper tungsten system normally specified by users of contacts.
1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Data Safety Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Keywords
contacts; copper; copper–tungsten; powder metallurgy; tungsten; tungsten–copper;
To find similar documents by ASTM Volume:
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Customers who bought this document also bought:
ASTM-A484Standard Specification for General Requirements for Stainless Steel Bars, Billets, and Forgings
ASTM-B488
Standard Specification for Electrodeposited Coatings of Gold for Engineering Uses
ASTM-F68
Standard Specification for Oxygen-Free Copper in Wrought Forms for Electron Devices
Document Number
ASTM-B702-93(2019)
Revision Level
1993 R19 EDITION
Status
Current
Modification Type
Reapproval
Publication Date
Nov. 1, 2019
Document Type
Specification
Page Count
3 pages
Committee Number
B02.05