ASTM-B708 › Historical Revision Information
Standard Specification for Tantalum and Tantalum Alloy Plate, Sheet, and Strip
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers unalloyed and alloyed tantalum plate, sheet, and strip.
1.2 The materials covered by this specification are:
1.2.1 R05200, unalloyed tantalum, electron-beam furnace or vacuum-arc melt, or both,
1.2.2 R05400, unalloyed tantalum, powder-metallurgy consolidation,
1.2.3 R05255, tantalum alloy, 90% tantalum 10% tungsten, electron-beam furnace of vacuum-arc melt, or both,
1.2.4 R05252, tantalum alloy, 97.5% tantalum 2.5% tungsten, electron-beam furnace or vacuum-arc melt, or both.
1.2.5 R05240, tantalum alloy, 60% tantalum, 40% nobium, electron-beam furnace or vacuum-arc melt.
1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 The following precautionary caveat pertains only to the test methods portion, Section 13, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Nickel alloys-plate/sheet/strip
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.99 (Other products of non-ferrous metals)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B708-98
Revision Level
1998 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 10, 1998
Document Type
Specification
Page Count
5 pages
Committee Number
B10.03