ASTM-B75 › Historical Revision Information
Standard Specification for Seamless Copper Tube
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification establishes the requirements for seamless round, rectangular, and square copper tube suitable for general engineering applications.
1.1.1 Tubes made from any of the following Copper UNS No. designations may be supplied unless otherwise specified in the contract or purchase order:
Copper UNS No. Type of Copper C10100 Oxygen-free electronic C10200 Oxygen-free without residual deoxidants C10300 Oxygen-free, extra low phosphorus C10800 Oxygen-free, low phosphorus C12000 Phosphorus deoxidized, low residual phosphorus C12200 Phosphorus deoxidized, high residual phosphorus1.2 The values stated in inch-pound units are the standard except for grain size values which are given in SI units.
1.3 This specification is the companion to SI Specification B75M; therefore no SI equivalents are presented in this specification.
1.4 The following hazard statement pertains only to the test method described in Sections 20.5.2.1, 21.2.9, and 21.2.10 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
seamless copper tube; seamless tube; tube; ICS Number Code 77.150.30 (Copper products)
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B75-99
Revision Level
1999 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 1999
Document Type
Specification
Page Count
7 pages
Committee Number
B05.04