ASTM-B757 › Historical Revision Information
Standard Specification for Nickel-Chromium-Molybdenum-Tungsten-Alloys (UNS N06110) Welded Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers welded UNS N06110 pipe in the annealed condition (temper) for general corrosion applications.
1.2 This specification covers pipe sizes in schedules shown in Table 1.
1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.
1.4 The following precautionary caveat pertains only to the test method portion, Section 13, of this specification: This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
nickel alloys-pipe; nickel-chromium-molybdenum-tungsten alloys; welding/welds-Ni/Ni alloy materials; pipe-Ni-Cr-Mo-W alloy, welded (for general corrosive service), UNS; N; ICS Number Code 77.150.40 (Nickel and chromium products)
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.150.40 (Nickel and chromium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B757-99
Revision Level
1999 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 10, 1999
Document Type
Specification
Page Count
5 pages
Committee Number
B02.07