Document Center is acquired by Nimonik

Scope

1.1 This specification establishes the requirements for seamless round, rectangular, and square copper tube suitable for general engineering applications.

1.1.1 Tubes made from any of the following Copper UNS No. designations may be supplied unless otherwise specified in the contract or purchase order:

Copper UNS No. Type of Copper
C10100 Oxygen-free electronic
C10200 Oxygen-free without residual deoxidants
C10300 Oxygen-free, extra low phosphorus
C10800 Oxygen-free, low phosphorus
C12000 Phosphorus deoxidized, low residual phosphorus
C12200 Phosphorus deoxidized, high residual phosphorus

1.2 The values stated in SI units are the standard.

1.3 This specification is the companion to inch-pound Specification B 75.

1.4 The following hazard statement pertains only to the test method described in Sections 20.5.2.1, 21.2.9, and 21.2.10 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

seamless copper tube; seamless tube; tube; ICS Number Code 77.150.30 (Copper products)

To find similar documents by ASTM Volume:

02.01 (Copper and Copper Alloys)

To find similar documents by classification:

77.150.30 (Copper products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.