ASTM-B806 › Historical Revision Information
Standard Specification for Copper Alloy Permanent Mold Castings for General Applications
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers the requirements for UNS C95300, C95400, C95410, C95500, C95800, C87500, C87800, C87850, and C89540 copper alloy permanent mold castings for general applications. UNS C95800 copper alloy used in sea water applications should be heat treated for better corrosion resistance. In general, alloys included in this specification are weldable. Mechanical properties like the tensile strength, yield strength and elongation are determined from separately cast test bar castings and should conform to the specified requirements.
Scope
1.1 This specification establishes requirements for copper alloy2 permanent mold castings for general applications. Nominal compositions of the alloys under this specification are shown in Table 1.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
Keywords
copper alloy castings; copper-base alloy castings; permanent mold castings
To find similar documents by ASTM Volume:
02.01 (Copper and Copper Alloys)
To find similar documents by classification:
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B806-14
Revision Level
2014 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
May 1, 2014
Document Type
Specification
Page Count
3 pages
Committee Number
B05.05