ASTM-B884 › Historical Revision Information
Standard Specification for Niobium-Titanium Alloy Billets, Bar and Rod for Superconducting Applications
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers niobium-titanium alloy billets, bars, and rods, at 46 to 48% titanium. This material is used in the manufacture of wire for superconducting applications.
1.2 The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independent of the other; SI values cannot be mixed with inch-pound values. SI units are stated in parentheses.
1.3 The following precautionary caveat pertains only to the test methods portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
niobium-titanium alloy
To find similar documents by ASTM Volume:
To find similar documents by classification:
77.120.50 (Titanium and titanium alloys)
77.150.99 (Other products of non-ferrous metals)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B884-97
Revision Level
1997 EDITION
Status
Superseded
Modification Type
New
Publication Date
Oct. 10, 1997
Document Type
Specification
Page Count
6 pages
Committee Number
B10.03