ASTM-B885 › Historical Revision Information
Standard Test Method for Presence of Foreign Matter on Printed Wiring Board Contacts
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method defines a resistance probing test for detecting the presence of foreign matter on Printed Wiring Board (PWB) contacts or fingers that adversely affects electrical performance. This test method is defined specifically for such fingers coated with gold. Application of this test method to other types of electrical contacts or to fingers coated with other materials may be possible and desirable but may require some changes in fixturing, procedures, or failure criteria.
1.2 Practice B 667 describes another contact resistance probe method that has more general application to electrical contacts of various materials and shapes. Practice B 667 should be used for more fundamental studies. This test method provides a fast inspection method for printed wiring board fingers.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar will all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method provides a way to detect contamination on printed wiring board fingers that affects the electrical performance of such fingers. Such contamination may arise during PWB manufacture, circuit assembly, or service life and may include solder mask, solder flux, hardened lubricants, dust, or other materials. This test method provides a nondestructive method of inspecting such fingers at any point in the life of the product including after original manufacture, after assembly of circuit components to the PWB, and after time in service such as when returned for repair. Because this test method uses two probes to finger contacts in series, it provides a sensitive test for contaminants that may increase electrical resistance when the fingers are plugged into an edgecard connector that typically makes contact to the finger through only one contact to finger interface.
Practice B 667
Keywords
contact resistance; contamination; edgecard connector; printed wiring board fingers; ICS Number Code 31.180 (Printed circuits and boards)
To find similar documents by ASTM Volume:
To find similar documents by classification:
31.180 (Printed circuits and boards)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B885-97(2003)
Revision Level
1997 R03 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 2003
Document Type
Test Method
Page Count
3 pages
Committee Number
B02.11