ASTM-B93 › Historical Revision Information
Standard Specification for Magnesium Alloys in Ingot Form for Sand Castings, Permanent Mold Castings, and Die Castings

ASTM-B93 - 2003 EDITION - SUPERSEDED -- See the following: ASTM-B93M
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Specification for Magnesium Alloys in Ingot Form for Sand Castings, Permanent Mold Castings, and Die Castings
ORDER

Scope

1.1 This specification covers magnesium alloys in ingot form for remelting for the manufacture of sand castings, permanent mold castings, investment castings, and die castings.

Note 1—Supplementary information pertaining to the alloys covered by this specification when used in the form of castings is given in Specifications B80, B94, B199 and B403.

1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.

Keywords

composition; die casting; high pressure die cast alloy; magnesium; permanent mold casting; sand casting; ICS Number Code 77.150.20 (Magnesium products)

To find similar documents by ASTM Volume:

02.02 (Aluminum and Magnesium Alloys)

To find similar documents by classification:

77.150.20 (Magnesium products)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-B93/B93M-03

Revision Level

2003 EDITION

Status

Superseded

Modification Type

Revision

Publication Date

Jan. 1, 2003

Document Type

Specification

Page Count

3 pages

Committee Number

B07.04