ASTM-B93 › Historical Revision Information
Standard Specification for Magnesium Alloys in Ingot Form for Sand Castings, Permanent Mold Castings, and Die Castings
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers magnesium alloys in ingot form for remelting for the manufacture of sand castings, permanent mold castings, investment castings, and die castings. The chemical composition shall conform to the requirements and limits prescribed in the specification. Samples for the chemical analysis may be taken from the molten metal when the ingot is poured or from the ingots.
Scope
1.1 This specification covers magnesium alloys in ingot form for remelting for the manufacture of sand castings, permanent mold castings, investment castings, and die castings.
Note 1—Supplementary information pertaining to the alloys covered by this specification when used in the form of castings is given in Specifications B80, B94, B199 and B403.
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
composition; die casting; high pressure die cast alloy ; magnesium; permanent mold casting; sand casting;composition; die casting; high pressure die cast alloy ; magnesium; permanent mold casting; sand casting; Investment castings--specifications; Magnesium alloys--specifications; Die casting magnesium alloys--specifications; Permanent mold castings--magnesium alloy; Sand castings (magnesium alloy); UNS M10100 (magnesium alloy, casting); UNS M10410 (magnesium alloy, casting); UNS M10600 (magnesium alloy, casting); UNS M11630 (magnesium alloy, casting); UNS M11800 (magnesium alloy, casting); UNS M11910 (magnesium alloy, casting); UNS M11912 (magnesium alloy, casting); UNS M11914 (magnesium alloy, casting); UNS M11920 (magnesium alloy, casting); ICS Number Code 77.120.20 (Magnesium and magnesium alloys)
To find similar documents by ASTM Volume:
02.02 (Aluminum and Magnesium Alloys)
To find similar documents by classification:
77.150.20 (Magnesium products)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-B93/B93M-09
Revision Level
2009 EDITION
Status
Superseded
Modification Type
Editorial Review Board change
Publication Date
Dec. 1, 2009
Document Type
Specification
Page Count
4 pages
Committee Number
B07.04