ASTM-C1073 Historical Revision Information
Standard Test Method for Hydraulic Activity of Ground Slag by Reaction with Alkali

ASTM-C1073 - 1997A R11 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Test Method for Hydraulic Activity of Slag Cement by Reaction with Alkali
ORDER

Scope

1.1 This test method covers the rapid determination of hydraulic activity of ground-granulated iron blast-furnace slag. This test method measures the accelerated strength development of the slag by using sodium hydroxide solution as mixing water and curing at elevated temperature.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A specific warning statement is given in Section 6.

1.4 The text of this standard references notes and footnotes which provide explanatory information. These notes and footnotes (excluding those in tables) shall not be considered as requirements of this standard.

Significance and Use

This test method can be used as a quality-control test for slag production from a single source after adequate correlation with tests stipulated in Specification C989.

This test method may be used as an evaluation technique for slag, when an appropriate correlation with various finenesses of slags from a specific source ground in a specific laboratory mill has been previously developed.

The hydraulic activity as measured by this test method on ground-slag samples can provide guidance to a manufacturer as to fineness level required to maintain a certain level of hydraulic activity.

While this test method is intended primarily as a quality control test, some studies have shown that the test method is capable of evaluating the hydraulic activity of slags from different sources.

Keywords

ground slag; hydraulic activity; slag; ICS Number Code 91.100.15 (Mineral materials and products)

To find similar documents by ASTM Volume:

04.02 (Concrete and Aggregates)

To find similar documents by classification:

91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-C1073-97a(2011)

Revision Level

1997A R11 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

Oct. 1, 2012

Document Type

Test Method

Page Count

3 pages

Committee Number

C09.27