ASTM-C1081 › Historical Revision Information
Standard Specification for Asbestos-Cement Corrugated Fill For Use in Cooling Towers
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers splash bar and corrugated sheet type asbestos-cement products used as cooling tower fill.
1.2 Drift eliminators or demisters, louvers, partitioning and casing panels are covered in Specifications C 1080. Asbestos-cement pipes are covered in Specification C 296 and Specifications C 428. Asbestos-cement flat sheet fill (heat exchange surfaces) are specified in Specification C 1082.
1.3 The values stated in the SI system are to be regarded as the standard. The inch-pound units in parentheses are for information only.
1.4 The following precautionary caveat pertains only to the Test Method portion, Section 8, of this Specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 8.1.3 for specific safety hazards.
Keywords
asbestos; asbestos-cement; cement; cooling tower; corrugated; fill; ICS Number Code 91.100.40 (Products in fibre-reinforced cement)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.40 (Products in fibre-reinforced cement)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1081-88
Revision Level
1988 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Oct. 31, 1988
Document Type
Specification
Page Count
3 pages
Committee Number
C17.03