Document Center is acquired by Nimonik

Scope

1.1 This specification covers splash bar, and corrugated sheet type asbestos-cement products used as cooling tower fill.

1.2 Drift eliminators or demisters, louvers, partitioning and casing panels are covered in Specifications C1080. Asbestos-cement pipes are covered in C296 and C428. Asbestos-cement flat sheet fill (heat exchange surfaces) are specified in Specification C1082.

1.3 The values stated in the SI system are to be regarded as the standard. The inch-pound units in parentheses are for information only.

1.4 The following precautionary caveat pertains only to the Test Method portion, Section 8, of this Specification: This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See 8.1.3 for specific safety hazard.

Keywords

Asbestos-cement products; Autoclaves; Cooling towers; Corrugated asbestos-cement products; Freezing and thawing; Harkort test; Pressed products; Splash bar; Water absorption-asbestos-cement products; corrugated fill-asbestos-cement, for use in cooling towers, spec

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

91.100.40 (Products in fibre-reinforced cement)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.