ASTM-C1082 › Historical Revision Information
Standard Specification for Asbestos-Cement Flat Sheet for Cooling Tower Fill
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification covers three classes of flat asbestos-cement sheets for use as cooling tower fill.
1.2 Specifically excluded from this specification are asbestos-cement products intended for use as tower partitioning and casing materials, splash bars, water distribution conduits, and demisters. Also excluded are corrugated sheets and splash bars used as cooling tower fill (heat exchange surfaces) that are covered in Specification C1081.
1.3 The values stated in the SI system are to be regarded as the standard. The inch-pound units in parentheses are provided for information only.
1.4 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Asbestos-cement products-sheet; Autoclaves; Cooling towers; Freezing and thawing; Harkort test; Pressed products; Silicon content; Water absorption-asbestos-cement products; asbestos-cement flat sheet for cooling tower fill, spec
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.40 (Products in fibre-reinforced cement)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1082-89
Revision Level
1989 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 27, 1989
Document Type
Specification
Page Count
2 pages
Committee Number
C17.03