ASTM-C1103M Historical Revision Information
Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines (Metric)

ASTM-C1103M - 1994 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines (Metric) (Withdrawn 2022)
ORDER

Scope

1.1 This practice covers procedures for testing the joints of installed precast concrete pipe sewer lines, when using either air or water under low pressure to demonstrate the integrity of the joint and the construction procedures. This practice is used for testing 675-mm and larger diameter precast concrete sewer lines utilizing rubber gasket sealed joints.

1.2 This practice is the metric companion of Practice C1103.

Note 1--The owner shall specify the following: who will conduct, observe, and furnish labor, material, and measuring devices and pay for the tests; who is responsible for determining local ground conditions; and whether an air or water test is to be used.

Note 2--Test criteria presented in this practice are similar to those in general use. Pipe 600-mm diameter and smaller may be accepted by infiltration or exfiltration testing utilizing Practice C969M or by low pressure air testing utilizing Practice C924M. Pipe greater than 600-mm diameter may be accepted by infiltration or exfiltration testing utilizing C969M.

Note 3--It should be understood that there is no correlation between air loss and water leakage.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety precautions are given in Section 6.

Keywords

acceptance criteria/testing; concrete pipe; field testing-concrete/aggregates; ground-water pressure; joints-concrete applications; pressure testing-concrete pipe; sewer pipe (concrete); joint acceptance testing of installed precast concrete pipe sewer lines; ICS Number Code 23.040.50 (Pipes and fittings of other materials)

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

23.040.50 (Pipes and fittings of other materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-C1103M-94

Revision Level

1994 EDITION

Status

Superseded

Modification Type

Reapproval

Publication Date

July 15, 1994

Document Type

Practice

Page Count

2 pages

Committee Number

C13.09