ASTM-C1115 › Standard Specification for Dense Elastomeric Silicone Rubber Gaskets and Accessories
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This specification describes products composed of dense elastomeric silicone rubber that are fabricated into gaskets and accessories (such as setting blocks, spacers, and shims) for use in sealing and glazing applications in building construction. These products are used to seal or serve as components of compression sealing systems between mechanically restrained surfaces in building construction and also as components in structural silicone sealant glazing systems.
1.2 The values stated in metric (SI) units are to be regarded as the standard. The inch-pound values given in parentheses are provided for information purposes only.
1.3 Test Method C1166, as referenced in this specification, should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment that takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use.
1.4 The following precautionary statement pertains only to the test method portion, Section 10, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Elastomeric materials; Gaskets; Rubber; Rubber-silicone; Seals; Setting blocks; Shims; Spacers; dense elastomeric silicone rubber gaskets/accessories, spec; ICS Number Code 83.140.50 (Seals)
To find similar documents by ASTM Volume:
04.07 (Building Seals and Sealants; Fire Standards; Dimension Stone)
To find similar documents by classification:
83.140.50 (Seals Seals for general use, see 21.140 and 23.040.80)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1115-17R22
Revision Level
2017 R22 EDITION
Status
Current
Modification Type
Revision
Publication Date
Jan. 19, 2022
Document Type
Specification
Page Count
5 pages
Committee Number
C24.73