ASTM-C1181 › Historical Revision Information
Standard Test Methods for Compressive Creep of Chemical-Resistant Polymer Machinery Grouts
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 These test methods cover a quantitative, comparative test for compressive creep of chemical-resistant grouting materials under a sustained load at a test temperature. Constant load is maintained using a bolt and spring washers. Measurements are made at laboratory temperature after exposure periods at the selected test temperature.
1.2 Test Method A outlines the molding techniques for an unbonded test specimen. Test Method B covers the molding techniques for a bonded test specimen.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Keywords
chemical-resistant; compressive creep; compressive deflection; creep; polymer machinery grouts; stress; ICS Number Code 83.080.01 (Plast in general)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
83.080.01 (Plastics in general)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1181-00
Revision Level
2000 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Sept. 10, 2000
Document Type
Test Method
Page Count
5 pages
Committee Number
C09.41