ASTM-C1195 › Historical Revision Information
Standard Test Method for Absorption of Architectural Cast Stone
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers the sampling, preparation of specimens, and determination of the absorption of architectural cast stone.
1.2 This test method describes two procedures: ( ) cold water and ( ) boiling water. The user of the test method should stipulate which is desired. If no stipulation is made, the cold water procedure will be used.
1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.
Keywords
Architectural cast stone; Concrete-precast; Water absorption-brick/clay/concrete products; absorption (cold/boiling water) of architectural cast stone, test
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1195-91(1995)
Revision Level
1991 R95 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Aug. 15, 1991
Document Type
Test Method
Page Count
2 pages
Committee Number
C27.20