Document Center is acquired by Nimonik

Scope

1.1 This test method covers the sampling, preparation of specimens, and determination of the absorption of architectural cast stone.

1.2 This test method describes two procedures: (1) cold water and (2) boiling water. The user of the test method should stipulate which is desired. If no stipulation is made, the cold water procedure will be used.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Significance and Use

This test method is to be used in determining the absorption of cast stone. Absorption is one measure of porosity of cast stone and, hence, its resistance to weathering and structural stress.

Keywords

Architectural cast stone; Precast concrete products; Water absorption--brick/clay/concrete products; ICS Number Code 91.100.15 (Mineral materials and products)

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

91.100.15 (Mineral materials and products Including earth, sands, clay, slates, stones, etc.)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.