ASTM-C1298 › Historical Revision Information
Standard Guide for the Design and Construction of Brick Liners for Industrial Chimneys
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This guide covers procedures for the design, construction, and serviceability of brick liners for industrial chimneys. The structural design criteria are applicable to vertical masonry cantilever structures supported only at their base, either by a foundation, a concrete pedestal, or by some means from the outer concrete shell. Excluded from direct consideration are single-wythe, sectional brick linings that are supported on a series of corbels cast in the outer chimney shell.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
chemical resistant mortar; chimney liner brick; construction requirments; counterweight system; design; details; leaning liner; masonry strength; pressurization; stability; stress; target wall
To find similar documents by ASTM Volume:
To find similar documents by classification:
81.080 (Refractories Including ceramic refractories)
91.060.40 (Chimneys, shafts, ducts Including flues and flue pipes)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1298-95
Revision Level
1995 EDITION
Status
Superseded
Modification Type
New
Publication Date
June 15, 1995
Document Type
Guide
Page Count
13 pages
Committee Number
C15.09