Document Center is acquired by Nimonik

Scope

1.1 This guide covers procedures for the design, construction, and serviceability of brick liners for industrial chimneys. The structural design criteria are applicable to vertical masonry cantilever structures supported only at their base, either by a foundation, a concrete pedestal, or by some means from the outer concrete shell. Excluded from direct consideration are single-wythe, sectional brick linings that are supported on a series of corbels cast in the outer chimney shell.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

chemical resistant mortar; chimney liner brick; construction requirements; counterweight system; design; details; leaning liner; masonry strength; pressurization; stability; stress; target wall; ICS Number Code 81.080 (Refractories); 91.060.40 (Chimneys, shafts, ducts)

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

81.080 (Refractories Including ceramic refractories)

91.060.40 (Chimneys, shafts, ducts Including flues and flue pipes)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.