ASTM-C1324 › Historical Revision Information
Standard Test Method for Examination and Analysis of Hardened Masonry Mortar
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers procedures for petrographic examination and chemical analysis of samples of masonry mortars. Based upon such examination and analysis, proportions of components in masonry mortars can be determined.
Note 1—Some historic mortars may contain non-resolvable constituents that may interfere. However, significant information may be obtained by petrographic examinations.
1.2 Interpretations and calculations of chemical results are dependent upon results of the petrographic examination. The use of the chemical results alone is contrary to the requirements of this test method.
1.3 Procedures for sampling, petrographic examination, chemical analysis, and calculations of component proportions are given in the following sections:
Section | |
Sampling | 7 |
Petrographic examination | 8 |
Chemical analysis | 9 |
Mortar proportion calculations | 10 |
Report | 11 |
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
chemical analysis; hardened mortar; masonry; petrographic examination; ICS Number Code 71.040.40 (Chemical analysis); 91.100.10 (Cement. Gypsum. Lime. Mortar)
To find similar documents by ASTM Volume:
To find similar documents by classification:
71.040.40 (Chemical analysis Including analysis of gases and surface chemical analysis)
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1324-02
Revision Level
2002 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Aug. 10, 2002
Document Type
Test Method
Page Count
6 pages
Committee Number
C12.02