ASTM-C1439 › Historical Revision Information
Standard Test Methods for Evaluating Latex and Powder Polymer Modifiers for use in Hydraulic Cement Concrete and Mortar
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 Most sections of ASTM test methods and practices for hydraulic cement, mortar and concrete apply to the preparation and testing of specimens made with polymer-modifiers. However, there are some exceptions, most notably curing, that need special procedures in order to develop the properties inherent with polymer-modification. These test methods cover these exceptions.
1.2 For testing polymer-modified mortar and concrete specimens, the procedures in this standard supersede those in the referenced ASTM test methods and practices. These test methods are not applicable to dry, packaged mortar and concrete.
1.4 The values stated in SI units are to be regarded as standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
These test methods are used to develop data for comparison with the requirements of Specification C 1438
Keywords
latex; latex polymer; polymer-modified concrete; polymer-modified mortar; powder polymer; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1439-99
Revision Level
1999 EDITION
Status
Superseded
Publication Date
July 10, 1999
Document Type
Test Method
Page Count
4 pages
Committee Number
C09.44