ASTM-C1449 › Historical Revision Information
Standard Specification for Non-Asbestos Fiber-Cement Nonpressure Sewer Pipe
The following bibliographic material is provided to assist you with your purchasing decision:
This specification covers requirements relating to non-asbestos fiber-cement non-pressure sewer pipe, joints, and fittings suitable for use with gravity flow, intended for sewerage and drainage applications from point of use to point of treatment or disposal. The types of pipe shall be shown as type I and type II corresponding to the chemical requirements. Fiber-cement sewer pipe furnished under this specification shall be designated as class I, II, III, IV, and V. The corresponding strength requirements are prescribed. The pipe shall be of laminar construction formed under pressure to a homogeneous structure and cured under natural or accelerated conditions to meet the chemical and physical requirements. Crushing tests, and longitudinal bending tests shall be conducted to meet the requirements prescribed. A hydrostatic pressure test shall be made on an assembly of two sections of pipe properly connected with a coupling to meet the requirements prescribed.
Scope
1.1 This specification covers requirements relating to non-asbestos fiber-cement non-pressure sewer pipe, joints, and fittings suitable for use with gravity flow, intended for sewerage and drainage applications from point of use to point of treatment or disposal. It defines certain conditions of manufacture, classification, characteristics, and acceptance tests applicable to these products.
1.2 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
Note 1: Rubber rings suitable for use with this pipe are covered in Specification D1869.
Note 2: This specification is issued for product standardization and purchasing purposes only, and does not include requirements for installation or the relationships between operating conditions and the strength characteristics of the various classifications of pipe. The purchaser is cautioned that he must correlate installation and operating conditions with the specified characteristics of the pipe.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
drainage; fiber-cement; nonpressure; pipe; sewer;; ICS Number Code 23.040.50 (Pipes and fittings of other materials)
To find similar documents by ASTM Volume:
To find similar documents by classification:
23.040.50 (Pipes and fittings of other materials)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C1449/C1449M-05a(2014)
Revision Level
2005A R14 EDITION
Status
Superseded
Modification Type
Reapproval
Publication Date
Jan. 1, 2015
Document Type
Specification
Page Count
6 pages
Committee Number
C17.02