Document Center is acquired by Nimonik

Scope

1.1 This test method covers determination of the length changes of hardened hydraulic-cement mortar and concrete due to causes other than externally applied forces and temperature changes.

1.2 The term "length change," as used here, is defined as an increase or decrease in a linear dimension of a test specimen which has been caused to change by any factor other than externally applied forces and temperature changes.

1.3 The values stated in inch-pound units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

Cement-mortars; Concrete-hardened; Hydraulic cement; Length-change; Mortar-cement mortar; Volume change; hardened hydraulic-cement mortar/concrete-length change, test; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)

To find similar documents by ASTM Volume:

04.02 (Concrete and Aggregates)

To find similar documents by classification:

91.100.10 (Cement. Gypsum. Lime. Mortar)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.