ASTM-C183 › Historical Revision Information
Standard Practice for Sampling and the Amount of Testing of Hydraulic Cement
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This practice covers procedures for sampling and for the amount of testing of hydraulic cement after it has been manufactured and is ready to be offered for sale.
1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units in parentheses are for information purposes only.
1.2.1 A ton as used in this practice is 907 kg (2000 lb).
1.2.2 Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in Standard IEEE/ASTM SI 10
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
The sampling procedures described are intended for use in the procurement of samples of hydraulic cement after it has been manufactured and is ready to be offered for sale. They are not intended as sampling procedures for quality control purposes during manufacturing. The testing procedures outlined cover the amount of testing to be done and provide guidance for reporting on conformance or non-conformance of cements with requirements of purchase specifications.
This practice is referenced as the procedure for sampling masonry cement (Specification C 91
Most building codes and construction specifications require that hydraulic cement to be used in the work meet the applicable requirements of the relevant purchase specifications, such as Specifications C 91
The procedures covered in this practice should be done by or for purchasers of hydraulic cement who are using a code or specification that requires sampling and testing to determine if the samples conform to the relevant acceptance specifications. The testing is done using specified methods to determine whether the samples yield test results that conform to the specification, and the tests serve as a basis for acceptance or rejection of the lot of material sampled.
It is neither intended nor required that all cements be tested using all the test methods referenced in Section 2.
Keywords
hydraulic cement; sampling; testing; Acceptance criteria/testing; Hydraulic cement concrete; Quality control (QC)--cement/concrete/masonry/aggregates; Sampling cement/cement products; Testing methods
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C183-08
Revision Level
2008 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Dec. 15, 2008
Document Type
Practice
Page Count
7 pages
Committee Number
C01.95