ASTM-C42 › Historical Revision Information
Standard Test Method for Obtaining and Testing Drilled Cores and Sawed Beams of Concrete
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers obtaining, preparing, and testing (1) cores drilled from concrete for length or compressive or splitting tensile strength determinations and (2) beams sawed from concrete for flexural strength determinations.
1.2 The values stated in inch-pound units are to be regarded as the standard.
1.3 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Change in length; Compression testing-cement/concrete; Concrete-flexural strength; Concrete-splitting tensile tests; Concrete-test specimens; Drilled cores; Flexural strength-concrete; Tension (tensile) properties/tests-splitting tensile strength; obtaining/testing drilled concrete cores/sawed beams, test; ICS Number Code 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C42-94
Revision Level
1994 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Oct. 15, 1994
Document Type
Test Method
Page Count
4 pages
Committee Number
C09.61