ASTM-C917 › Historical Revision Information
Standard Test Method for Evaluation of Cement Strength Uniformity From a Single Source
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method is intended for use in instances in which the purchaser desires information on the strength uniformity of a hydraulic cement produced at a single source. It is intended that this test method normally be used for the predominant cement manufactured at a cement plant. Guidelines for sampling, testing, presentation of results, and evaluation are given.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Significance and Use
This test method is designed to present in a standardized format information on the variability of strength of cement from a single source over a period of time. It can be applied to all hydraulic cements covered in Specifications C 150
Note 1—It should be recognized that concrete strength variability is influenced by other factors in addition to cement strength variability.
Keywords
cement; sampling; statistics; strength; uniformity; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
To find similar documents by ASTM Volume:
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C917-05
Revision Level
2005 EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Feb. 1, 2005
Document Type
Test Method
Page Count
11 pages
Committee Number
C01.27