ASTM-C924M Historical Revision Information
Standard Practice for Testing Concrete Pipe Sewer Lines by Low-Pressure Air Test Method (Metric) (Withdrawn 2013)

ASTM-C924M - 1989 EDITION - SUPERSEDED
Show Complete Document History

Document Center Inc. is an authorized dealer of ASTM standards.
The following bibliographic material is provided to assist you with your purchasing decision:

Standard Practice for Testing Concrete Pipe Sewer Lines by Low-Pressure Air Test Method (Metric) (Withdrawn 2013)
ORDER

Scope

1.1 This practice covers procedures for testing concrete pipe sewer lines, when using the low-pressure air test method to demonstrate the integrity of the installed material and the construction procedures. This practice is used for testing 100 to 600-mm circular concrete pipe sewer lines utilizing gasketed joints.

1.2 This practice may also be used as a preliminary test to enable the installer to demonstrate the condition of the line prior to backfill.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use (see Section 6, Safety Precautions).

1.4 This practice is the metric companion to Practice C924.

Note 1-Air test criteria presented in this practice are similar to those in general use. The test and criteria have been used widely and successfully in testing smaller diameter pipe, but additional data are required to confirm the safety and applicability or develop criteria for pipe larger than 600 mm in diameter. Larger pipe may be accepted more conveniently by visual inspection and individual joint testing.

Note 2-It should be understood that no correlation has been found between air loss and water leakage.

Keywords

concrete; pipe; sewer lines; low-pressure air test; gasketed joints

To find similar documents by ASTM Volume:

04.05 (Chemical-Resistant Nonmetallic Materials; Vitrified Clay Pipe; Concrete Pipe; Fiber-Reinforced Cement Products; Mortars and Grouts; Masonry; Precast Concrete)

To find similar documents by classification:

13.060.30 (Sewage water Including sewage water disposal and treatment Liquid wastes, see 13.030.20 Drainage systems, see 91.140.80 Sewage systems, see 93.030)

23.040.50 (Pipes and fittings of other materials)

This document comes with our free Notification Service, good for the life of the document.

This document is available in either Paper or PDF format.

Document Number

ASTM-C924M-89

Revision Level

1989 EDITION

Status

Superseded

Publication Date

Jan. 27, 1989

Document Type

Practice

Page Count

3 pages

Committee Number

C13.09