ASTM-C939 › Historical Revision Information
Standard Test Method for Flow of Grout for Preplaced-Aggregate Concrete (Flow Cone Method)
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a procedure, used both in the laboratory and in the field, for determining the time of efflux of a specified volume of fluid hydraulic cement grout through a standardized flow cone and used for preplaced-aggregate (PA) concrete; however, the test method may also be used for other fluid grouts.
1.2 It is for use with neat grout and with grouts containing fine aggregate all passing a 2.36-mm (No. 8) sieve.
1.3 This test method is intended for use with grout having an efflux time of 35 s or less.
1.4 When efflux time exceeds 35 s, flowability is better determined by flow table, found in Test Method C109, using 5 drops in 3 s.
1.5 The values stated in SI units are to be regarded as the standard.
1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
flow cone; grout; preplaced-aggregate concrete; time of efflux; ICS Number Code 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C0939_C0939M-22
Revision Level
2022 EDITION
Status
Current
Modification Type
Revision
Publication Date
Nov. 15, 2022
Document Type
Test Method
Page Count
3 pages
Committee Number
C09.41