ASTM-C944 › Historical Revision Information
Standard Test Method for Abrasion Resistance of Concrete or Mortar Surfaces by the Rotating-Cutter Method
The following bibliographic material is provided to assist you with your purchasing decision:
Scope
1.1 This test method covers a procedure for determining the resistance of either concrete or mortar to abrasion. It is not intended to be used as an alternative to Test Method C418, or Test Method C779.
1.2 The values stated in SI units are to be regarded as standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Keywords
Abrasion resistance; emconcrete/mortar; Concrete; emabrasion resistance; Impact testing; Mortar; Rotating-cutter method; Wear testing; concrete/mortar surfaces; emabrasion resistance, by rotating-cutter; ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar); 91.100.30 (Concrete and concrete products)
To find similar documents by ASTM Volume:
04.02 (Concrete and Aggregates)
To find similar documents by classification:
91.100.10 (Cement. Gypsum. Lime. Mortar)
91.100.30 (Concrete and concrete products Including admixtures)
This document comes with our free Notification Service, good for the life of the document.
This document is available in either Paper or PDF format.
Document Number
ASTM-C944-90a
Revision Level
1990A EDITION
Status
Superseded
Modification Type
Revision
Publication Date
Nov. 30, 1990
Document Type
Test Method
Page Count
3 pages
Committee Number
C09.62